We run a Manual J load calculation before recommending equipment size, not just matching your old unit's tonnage.
Written estimates cover equipment, labor, and any necessary duct modifications together.
If you're dealing with an old system finally beyond economical repair, a home addition that needs its own conditioned zone, or a builder-grade unit that's never kept up with the house, you already know an oversized or undersized system installed without a real load calculation will short-cycle, run inefficiently, or never keep the house comfortable — for its entire lifespan.

Waiting rarely saves money and often turns a same-day repair into a longer, more involved job.
Our technicians treat every HVAC installation call in Canby, OR the same way, whether it's a straightforward fix or a stubborn intermittent fault that two other companies already missed.
We're licensed, insured, and staffed with techs who've spent years specifically on HVAC installation, not general handyman work with an HVAC certificate bolted on.

Oversizing is as much a problem as undersizing — it causes short cycling and poor humidity control.
Manufacturer warranty registration is handled at install to protect your coverage.
No mid-install upsells — the scope is agreed before work starts.
A new high-efficiency system on old, leaky, undersized ductwork won't perform to spec.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our HVAC installation technicians handle across Canby, OR.
Old equipment is removed and disposed of properly as part of the job. Techs handling full system replacement installation carry the specific parts and tools this job calls for, not a generic kit.
Ductwork is designed alongside the equipment, not retrofitted after the fact. Techs handling new construction hvac installation carry the specific parts and tools this job calls for, not a generic kit.
Line set routing and mounting are planned to minimize visible exterior equipment. This is one of the most requested HVAC installation calls we get across Canby, OR.
Zoning design accounts for actual room-by-room load, not a generic split. This is one of the most requested HVAC installation calls we get across Canby, OR.
Static pressure is verified after installation, not assumed. This is one of the most requested HVAC installation calls we get across Canby, OR.
We explain the real-world efficiency gains versus the added upfront cost honestly. Techs handling high-efficiency system upgrades carry the specific parts and tools this job calls for, not a generic kit.

Schedule an in-home consultation rather than a phone-only quote — sizing requires an actual site visit.
A technician arrives to perform the load calculation and inspect existing ductwork and electrical.
Financing and permit timelines are explained clearly before you commit.
Installation is scheduled at a confirmed date, with permits and inspections built into the timeline.

This crew actually measured the house and explained why our old system was oversized the whole time.
They designed a dedicated duct run for it instead of just tying into the existing trunk line.
Clean line-set routing, barely visible from outside.
Handled the permit and inspection process without me having to chase anyone down.

Matching an old unit's tonnage without recalculating is a common and costly mistake.
In most jurisdictions, yes — we handle the permit application and schedule required inspections as part of the job.
A mismatch between new equipment and old ducts is a leading cause of underperformance.
Straightforward system swaps often complete in a day; ductwork modifications or new construction extend the timeline.
Two-stage equipment runs at a lower capacity most of the time, improving comfort and efficiency, at a higher upfront cost.
Yes — they're often the practical choice when extending existing ductwork isn't feasible.

Our HVAC installation crews are positioned throughout Canby, OR to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Canby Service